LEEDuser Expert 537 thumbs up September 22, 2020- 12:46 pm this one has been a bit of struggle for us as well.  Laboratory's that conduct the tests must be accredited under ISO/IEC 17025... and/or... organizations that certify manufacturer's claims must be accredited under ISO Guide 17065. This is what the LEED reviewer is looking for. Statements and product data from manufacturers is no longer accepted...

of using ISO 14000 and ISO 9000. Those are tough documentation requirements and outside the reach of the vast majority of small and medium sized companies. We don't have the money to hire consultants...

that for recycled content claims the material must meet the definition of ISO 14021 as required by LEED.” Note that the ruling leaves the classification up to the project team. If you are a fabricator/supplier, work...

Dave Hubka Practice Leader- Sustainability EUA LEEDuser Expert 537 thumbs up May 10, 2019- 2:01 pm Hello Mike, We have found a vehicle charger that meets the ISO 15118 requirement. check out...

of the manufacture. ISO 21930 explicitly says you cannot compare cradle to gate EPD’s.  So responsible manufacturers supplying type III EPD cannot send Type III EPD’s to a knowledgeable third party to compare....

not to exceed a concentration limit of 0.05 ppm of formaldehyde (0.06 mg/m 2-h when expressed as emission rate) as tested following either EN-717-1:2004, following ISO 16000-3: 2010, ISO 16000-6: 2011, ISO 16000-9: 2006, ISO 16000-11:2006, or following CEN/TS 16516: 2013 either in conjunction with AgBB or with Belgian or French legislation on VOC emission class labeling." I should expect that this could...

Paula Melton Editorial Director BuildingGreen, Inc. LEEDuser Expert 183 thumbs up December 15, 2015- 2:39 pm Petr, can you please clarify what you mean by A4 and A5? I'm not sure I understand your question. Log in or register to post comments Petr Vogel Specialist Consultant EkoWATT CZ LEEDuser Basic Member 4 thumbs up December 16, 2015- 3:20 am Paula, I am using the phases listed in ISO...

vibration, noise, and user fatigue, as reported in the user manual in accordance with ISO 5349-1 for arm vibrations, ISO 2631–1 for vibration to the whole body, and ISO 11201 for sound pressure at operator’s...

and are hoping to claim 1.5 for EPDs meeting the definition of Product-specific Type III EPD "which conform to ISO 14025 and EN 15804 or ISO 21930 and have at least a cradle to gate scope." I agree...

Pellegrino Technical Director Centek Laboratories, LLC LEEDuser Basic Member 16 thumbs up June 25, 2024- 10:11 am Depending on the size of the building you can do the IAQ testing from a certified ISO...