Dear all,

We have a project targeting LEED BD+C: Core & Shell. My question is how to model whole-building energy simulation? Do we need to take into account the energy consumption of...

I am modeling a new building(Laboratory/office) on a university campus following LEED v4 Option 1, Whole Building Energy Simulation. New Building is 3 story and 69,500 sq.ft . Chilled water will...

Hi,

We have project in Pakistan and we had done all measures for LEED certification, but due to some client personal reasons we were not able to register this project with USGBC and now...

Hello everyone,
We are working with a building that has a complicated geometry, and the selection of the baseline system is not that evident. We are able to identify 5 main floors, but it...

I read in paragraph 9.4.1.2 b. that "an occupant sensor or a timer switch shall be installed (...) in: (...) 6. office spaces up to 76.2m2".
Does it mean that for bigger offices (i.e. 100m2...

Hi all,
Could anyone clarify if Ireland is in climate zone 5A or 5C?

Thanks in advance

In case you have not seen this relatively new guide I would highly recommend it to help with your modeling issues.

ANSI/ASHRAE/IES Standard 90.1-2010 Performance Rating Method Reference...

Hello,

We have a speed skating oval project. Should the energy used for ice rink modeled as process load? We think this will be the major energy consumption. Can we consider the energy...

Since the energy model is based off of an existing building. Do I still need to perform parametric rotational runs (0 deg, 90 deg, 180 deg, and 270 deg) for a baseline model based on the...

Hi,

I'm working on a pre-assessment for a project in Morocco and would like to see the minimum wall insulation.
I checked in ASHRAE 90.1-2010 but Morocco is not listed in Table B3...