Hi, My project in Europe is targeting this MR4 credit with the REACH optimisation option. My question is: can I use PEPs that shows environmental performance and same time states compliance with...

Can someone please answer this? Log in or register to post comments 0 Vote up! The LEED requirement goes above and beyond REACH, in specifying a 100 ppm threshold, which is higher than a 1,000 ppm threshold.  I would qualify the following by saying that I am not an expert in REACH specifically, but based on the language you have shared, the REACH documentation referenced by Charline is not sufficient at only 1,000 ppm. Please search the LEEDuser forum for more on this. I think this question may have been a duplicate which was answered previously. Log in or register to post comments 1 Vote up! It seems...

Hi, 

I have seen a couple posts about how to count gravel in a nonroof measure. However, I am wondering if gravel counts in the "Total site paving area" of the calculation. 

My...

5879 thumbs up July 5, 2024- 10:30 am Your question is not appropriate for this particular forum. From an energy perspective such an air cleaning device would be considered a process load and simply...

Hello there, the requirement in 4.1 specifies to designate an area for a pollinator garden(Designate a portion of the habitat area for a pollinator garden consisting of native flowering...

I have a question regarding LEED v4, LEED v4 - EAc2 (Optimize Energy Performance) & EAc5 (Renewable Energy).

One of our clients is developing a hotel in a site where, due to landscape...

Dear all,

Is powder coating mixed with water on the jobsite is wet applied products ? technically, the initial product is powder, it is not "wet". Is difficult to get information about...

Our firm has completed this pilot credit a few times now, and we seem to learn something new every time we get review comments back. 

The first important lesson we learned is that in the...

The LEED credit language (International Tips) states that EMICODE EC1 can be used if formaldehyde limit of 10 micrograms per cubic meter after 28 days is also met. Why are they asking for this...