I am working on a LEED for Homes project. The project has AHU units, Heat pumps and DOAS. All dwelling units has HPs.

I've scrolled, searched and reviewed the comments here on the thread and I'm still not clear on whether Laminating/Contact adhesives used for bonding laminates to substrates for shop assembled mill

Our project (UCSF Block 33, SF CA) has found this credit to be worthwhile to pursue, as safety should live in every aspect of a construction project.  However, the team noted that it would hav

We are doing a university housing project and have been basing it off of the BD+C New Construction but for this section if we are able to do it under School-NC we would be able to get the 4 points

As part of the requirements for this pilot credit, we are noting our participation in the Forum. One of the questions listed asks about the number of meetings (i.e.

Samples to be tested must be taken from soils that are disturbed and will be revegetated. Restored soil must meet existing soil attributes.

We have several single zone RTU's that will need direct airflow monitors because the units have DCV.  The contractor says the low OA alarm will be located on the units at the roof.  They

Looking for suggestions on how to determine the parking ratio for a Fire Station.  There doesn't seem to be any use within the Base Ratios Table that align with a Fire Station.

Can DES cooling tower serving the project be used to demonstrate water consumption reduction for cooling tower water use credit?

Our project is pursuing LEED v4 BD+C certification and is a University building.