I am currently working on a major project in South Africa that will provide diverse uses to the building occupants only as the site is fully enclosed for security reasons.

We are working on a project where a significant amount of the domestic hot water ring feed piping will be cast into the concrete walls, and the designer is querying if these pipes will need to be i

Two projects, we've received the following comment: "Note that LEED Interpretation 10098 allows for a portion of the entryway system to be located outside of the building, if covered, but only when

Hi, on a recent project we were requested to provide evidence that 5 buildings built within the last three years did not have carbon monoxide sensors installed in the basement car parks in order to

I am currently working on a project in Kenya. The cooling load for the commercial office tower is around 1900RT. This project will attempt for LEED CS and will be targeting Silver rating.

Hi, There are several spaces in a project I'm working on that have been designed with an occupancy sensor without an override switch but each individual work station does have controllable (on/off

Hi, I'm working on a pre-assessment for a project in Morocco and would like to see the minimum wall insulation. I checked in ASHRAE 90.1-2010 but Morocco is not listed in Table B3 International Cl

In response to the ASHRAE 90.1:2007 mandatory requirements for the efficiency of 60Hz motors, some had used the European IE2 standard for 50Hz motors and demonstrated equivalency.

Hi, I am working on an office building and the team is considering to include a car wash bay. Would I be able to classify this as process water and exclude it from the WEp1 calculation?

Good day, we have a project that is naturally ventilated. ASHRAE 90.1 2007 states that the energy cost budget method cannot be used for designs with no mechanical systems.