My project registered for LEED 2009, mixed use building with 2 towers on the same podium. At first the project registered for LEED only 1 tower but later on the owner decided to registered for...

for circulation, the MPR2 Supplemental Guidance would define your project as two separate buildings. There is another discussion on the PIf2 forum that addresses this in greater depth and provides links to the MPR...

Good morning. I am trying to register a project that is 7,893.3 square feet. I see that it wont accept it on leedonline without it being 8,000?

However I see in the requirements that it...

Jorge Lopez de Obeso Architect / Environmental adviser eosis Consulting LEEDuser Basic Member 20 thumbs up September 30, 2013- 4:39 pm The minimum floor area for LEED NC is 1000 square feet. You should post this question under the rating system forum for LEED NC, not LEED CI.;) Log in or register to post comments ...

Tristan Roberts Representative Vermont House of Representatives LEEDuser Expert 11477 thumbs up March 21, 2013- 12:18 pm Jason, this is really a question about MPR3 —please read the guidance there and post to that forum. Thanks, and sorry for the slow reply. Log in or register to post comments RIM Architects RIM Architects LEEDuser Basic Member 3 thumbs up March 28, 2013- 4:00 pm I had to research a similar situation. Here is the relevant MPR guidance. Note that this changed a bit between the original guidance (2010) and Rev2 (09/01/2011) from MPR Guidance Rev2; p26 "If...

We saw the CI Fees table and, since it caused so much impression about having a such small CI Retail and paying the same that a 50000sf project... we just want to make sure that this is it......