Hi.

Hope some can help.

In the LEED 2009 version you had to enter the energy consumption for the different measured systems from the Whole building simulation in ordre to see in the...

I'm funneling this question on behalf my mechanical engineer:

Our total breakdown of energy use is as follows:

Total energy use all forms: 543 E10^6...

According to the LEED Credit EA Advanced Energy Metering it is mandatory to “install advanced energy metering for… any individual energy end uses that represent 10% or more of the...

The credit states "Whole-building electricity meters should record the power factor, if appropriate."

How does one determine when it is appropriate to record power factor?

Hello all,

our project is a Data Center that every single part of it will be metered. Each rack will have two meters while also every electrical panel will have each own meter. If we add...

Does "Electricity meters must record both consumption and demand" mean that both...

Hi Marcus,

I'm working on a 200-unit residential building and we are looking at feasibility of this credit. Our total lighting load is over 10% of the energy use so we plan on metering it...

Hi Marcus,

We are working on a building which will have the following uses: offices, laboratory (pharmaceutical), showers and changing facilities, canteen and a smaller bar. This building...

Hello
The USGBC approved Data template for Building Energy Metering is locked/protected. It only has 2 meter tabs. My project has 60+ different meters to input. Since the template is locked...

My project is a manufacturing building where the "widget makers" consume about 75% of the total annual energy. Hence there are not other 10%+ individual energy end use consumers of the project...