Is there a...

The LEED v4 Guide steps that it's possible only apply any savings from ON-SITE...

Hi,
I am trying to work out the best way to model a heated (cold climate) bus storage facility in the baseline. The proposed has supply fans and exhaust fans with heat recovery and a...

LEED V4 homes awards ( and generously) for residential projects with areas smaller than an accepted reference standard, and deducts points for residential units exceeding these standards. Anyone...

I'm filling out the information from the energy model to the LEED v4 Minimum Performance Calculator and i noticed a check mark next to each end-use when filling out energy consumption and power...

Marcus Sheffer LEED Fellow 7group / Energy Opportunities LEEDuser Expert 5903 thumbs up June 1, 2017- 2:19 pm This only applies to LEED v2009 projects. Please post in the appropriate forum and I will respond. Log in or register to post comments ...

I am working on a project that is approx. 24,600sf which includes 11,600s.f. of major renovation with 13,000s.f new construction. We are using Option 1 Whole Building Simulation.

How do I...

Hi all,

We are looking to certify a new building on a higher-ed campus that will be sharing HVAC systems with an existing building. The existing building will likely not pursue...

We are doing certification for a beverage factory. The factory requires chilled water for process load that is served by 2*1080 kW Evaporatively cooled Screw chillers. The same serves for air...

Hi, Is there any precedent for being able to exclude fuel refinery energy from an energy model. Usually refinery of diesel would be done offsite for a typical fleet facility (therefore no energy...