With reference to Service Hot Water should the following baseline inputs match the proposed;

If not where can I find good guidnace on how these baseline inputs can be obtained.

...

Hi,

I am working on a Leed campus project where there is 3 separate buildings which each consist of retail units on the ground floor and office units above. There is two levels of...

I am trying to establish the minimum chillier efficiency we are permitted to use in our PRM model. We have spec'd an air cooled chiller. In terms of understanding the minimum efficiency permitted...

I have a reviewer requesting that we oversize the PROPOSED case for a "possibly conditioned in the future" warehouse.
We have usually modeled the BASELINE case and PROPOSED case identical,...

How should one model existing glazing U-Values and Solar Heat Gain values when they are unknown (they were installed 24 years ago). I am referring to the Baseline Model ASHRAE Table G3.1 5f

Hi all,

I am working on a LEED 2009 NC project with IES energy modelling. Could anybody advise what documents need to be submitted for EAp2 and EAc1 certifications?

I suppose BPRM...

We are working on a project with two buildings on one site, one commercial C&S, one Hotel. The two buildings are sharing some thermal plant, but it is only a condenser water loop – one...

Hi, In relation to Table 1.4 where can one get "Annual Equivalent Full Load Hours of...

How does one know what baseline glazing type to model. Table 5.5-5 list various Fenestration types but it is not clar which one should be used. Maybe somebody can clarify ?

Thanks.

We are using packaged...