I have a general doubt regarding peak cooling load which is to be taken in baseline case for sizing the chillers. We generally model the base case for any building in Design Builder. 

What...

Hi all-

I recieved a comment from the...

Anurag Ghosh LEEDuser Basic Member January 27, 2025- 9:57 am Anyone on the above query? Log in or register to post comments Tyler Thumma 7Group LEEDuser Expert 67 thumbs up February 21, 2025- 11:01 am 1. This issue would require troubleshooting of the modeling inputs which it outside the scope of this forum. I recommend contacting the software support team if you are unable to resolve this. 2. The Baseline system is determined using Table G3.1.1-3 based on building type/size and climate zone, with additional modifications for dehumidification as outlined by Section G3.1.3.18.  Log in or register...

Hi,

I am modeling a mixed-use building using ASHRAE 90.1 2010. The building uses four Heat pump water heater connected to Geothermal loop. The Heat pump is connected to three storage tanks...

Hi to all,

I have a bit of confusion between the fan power allowance (table 6.5.3.1.1 A-B in ASHRAE 90.1) and the baseline fan power (table G3.1.2.9). I am working on an energy model for a...

Hi Everyone,

A project I'm modelling has a MAHU supplying 1800 l/s of Outdoor Air to the kitchen area to compensate for the 2000 l/s exhaust from the kitchen ecology unit. I have two...

Tyler Thumma 7Group LEEDuser Expert 67 thumbs up February 21, 2025- 11:31 am 1. This issue would require troubleshooting of the modeling inputs which it outside the scope of this forum. I recommend contacting the software support team if you are unable to resolve this. 2. The Baseline system is determined using Table G3.1.1-3 based on building type/size and climate zone, with additional modifications for dehumidification as outlined by Section G3.1.3.18.  Log in or register to post comments Anurag Ghosh LEEDuser Basic Member February 22, 2025- 8:45 am Hi Tyler, I would like to reclarify whether such reheat coils...

We are working on a project pursuing LEED v4.1 certification using the Appendix G Performance Path. The air-cooled chiller in our design complies with the IPLV (Integrated Part Load Value)...

Hi All,

Is it possible and if so, how would you justify savings in plug and process loads for an interior fit out energy model vs baseline? Can you claim a percentage reduction if

...

Does anyone know if projects registered in LEED v4 are eligible to upgrade to LEED v5 for specific credits? 

I'm working on a new science / health sciences building on the UW Eau Claire...