Hi,
How should be the compliance (of 0.25gpc) for sensor based lavatory faucet be checked if the manufacturer mentions only “ adjustable from 1 - 20 minutes “ , the model in question is...

According to ASHRAE 90.1-2007 Table G3.1.5 (f) for existing building envelopes, the baseline building design shall reflect existing conditions prior to any revisions that are part of the scope of...

We are working on a 30+ acre medical campus for a single developer. There will be a total of 9 buildings in this development, and all buildings will pursue LEED certification. I am trying to...

LEED v4 has a table (table 4) on page 58 that stipulates specific numbers of gallons of water allowable to either sterilize or wash in instrument tray. can anyone comment from where these values...

thumbs up December 19, 2014- 9:22 am Keith- Thanks so much for monitoring and contributing to this forum!! Your response is spot on. I just wanted to note that the default recycled content value for steel...

The overall process load of our project turns out to be in the vicinity of 15% only. We are aware that 15% is absurdly low and unusual for plants. The factory owner, nevertheless, sent us a full...

Shall the person who enters his/her initials under signatory section ( for example EAp2-1, 2-2, 2-3 ) be registered mechanical engineer (PE) ? If so, can you please let me know where this...

may be problematic if you cannot get documentation for the entire site. Finally, this post is in the NC-2009 MPR3 forum, but LEEDv3 MPRs do not apply to v2.2 projects. NCv2.2 boundary rules were a bit...

We have submitted an addition project for Design and Construction review under the new construction and renovation system. We just recently received a mid review clarification requesting to...

Through a series of circumstances, we are in the appeal process to try and meet WEp1. We have determined that we can either spend a significant amount of money to install two additional urinals...