Hi LeedUsers, I have one simple question. According to section G3.1.1 of ASHRAE 90.1 Standard each floor for system 5 through 8 shall be modeled with a separate HVAC system.

For a building with an elevation with 70% glazing and the others with less than 40%, how would the baseline elevations be modelled?

Our project is located at site that the surrounding site partially already developed and able to meet the development density requirement.

Hello, a question concerning IEQc8.1 & IEQc8.2 . Can we use the net floor area instead of gross floor area for the simulation in Matrix_Table IEQ-1 Daylight and views? I would like to use t

We have a LEED v2009 CS Project - existing building major renovation. Most of the systems will not be touched and there will be the addition of a couple new mechanical units.

Hi, the CI project I am working on uses only the base building system supply for meeting rooms with between 2 and 8 people.

Hi All, Currently working on a project with a nearby building under construction. We anticipate the building construction to finish slightly after our project.

Hi, I am trying to document the efficiency for comms room AC units and a data centre down flow AC units. As we are in Europe the efficiency is quoted by manufacturers in EER.

Dear all Our production area is sewing machines so we install table fan with switches in every sewing table.

Hello, I have been trying to find the guidance document that addresses the rating system switch requirements (from NC to HC) but haven't had luck. Could someone please post the link?