Hello, a question concerning IEQc8.1 & IEQc8.2 . Can we use the net floor area instead of gross floor area for the simulation in Matrix_Table IEQ-1 Daylight and views? I would like to use t

We have a LEED v2009 CS Project - existing building major renovation. Most of the systems will not be touched and there will be the addition of a couple new mechanical units.

Hi, the CI project I am working on uses only the base building system supply for meeting rooms with between 2 and 8 people.

Hi All, Currently working on a project with a nearby building under construction. We anticipate the building construction to finish slightly after our project.

Hi, I am trying to document the efficiency for comms room AC units and a data centre down flow AC units. As we are in Europe the efficiency is quoted by manufacturers in EER.

Dear all Our production area is sewing machines so we install table fan with switches in every sewing table.

Hello, I have been trying to find the guidance document that addresses the rating system switch requirements (from NC to HC) but haven't had luck. Could someone please post the link?

Our project is using greywater for landscape irrigation, likely 100%. The project will have a small community garden where residents can grow their own food for consumption.

Hello All, I am piggy backing off a discussion under EQc4.5 found at the link below:(http://www.leeduser.com/credit/ci-2009/ieqc4.5#comment-50494) in reference to guestroom furniture for a hotel.

Does anyone have any experience with blue roofs? Would LEED accept a minimum of 50% of the roof being covered by a blue roof rather than a green roof? I can't find any precedent for this.