Hi i am doing a feasibility report on LEED certifying a couple field houses owned by public parks. The problem I am facing is that there is no sub metering so all utilities account for the whole...

Thank you for the information Tristan.

Would you perhaps know when the registration under 2009 ends. I understood that it will be possible to register projects under 2009 for some time...

I opted-in to the prescriptive CMP path near the initial deadline in 2011, so I am close to my first renewal. I already have all of my required LEED_specific hours, but need a few hours in...

under the discussions for EQp1 or your particular credit on the CI and the NC forum. I recall a discussion about "diversity factor" in the ventilation rate calculations that might apply to your...

I am also an independent LEED consultant that is considering having to change my membership from regular to Silver because I have some large projects coming up that will have a substantial...

My interpretation is correct. Only Silver and higher memberships get the member discounts for LEED project registration and certification fees.

...

Tristan Roberts Representative Vermont House of Representatives LEEDuser Expert 11477 thumbs up May 22, 2013- 7:41 am Hi Lennart, your question about vacancies would best be posted over on our MPR5 forum, where you can also read some good guidance.With your volume question, can you clarify what you're trying to get at? Log in or register to post comments Karen Joslin principal Joslin Consulting LEEDuser Basic Member 216 thumbs up August 3, 2013- 4:26 pm If the question is can the LEED compliance and documentation account for only a partially occupied building, unless it is CS/CI the answer I think...

With the new Materials and Resources credits in LEED v4, Environmental Product Declarations and Health Product Declarations seem to be the way of the future for product documentation. However,...

We have received the review report from the assessor for our office project. It has been stated that- ''The daily average value should typically be higher than the peak value.'' This statement...

Hi, I'm trying to interpret this appendix as well and cannot get past understanding whether my project is a Case A, Case B or Case C? Can anyone shed some light on this? Thank you.