If manufacturer documentation is unavailable and the flow/fixture rate is unknown is it allowed to physically measure and time water consumption rates for at least a 20% of the fixtures of each fix

I am trying to figure out which cost to put in here. Another post said it was savings, although I can't find anything under the credit intent or resources for this specific item.

For an existing building undergoing major renovation how should the existing water fixtures be handled as far as WE prerequisite is concerned?

Thinking about pursuing this credit as an innovation for a LEEDv2009 Schools project. I'm confused about the requirements, however.

After a design or construction submittal review, if one (or more) of the ID credits is not accepted, may it be replaced with a different ID attempt on the re-submittal? Myles Huddart LEED AP BD+C

Hello all and a happy new year, I am wondering if anyone knows of a thermostat that can also measure and display humidity and CO2 levels? We are trying to find a way to cut down on the number of s

The owner would like to eliminate economizers on a few of the air handlers.

My project uses lot of steel and that is a very large portion of the total material budget. The supplier has not provided cut sheets to confirm the recycled content of steel.

Dear All, I am modeling a project which still has no exterior lighting design (the owner will decide on this when the building is almost complete). In the preliminary design review, I put the val

These reports are very wide range ...but the credit is dealing with sources of raw material extraction.....?