If air economizers are not required to be modeled in the baseline system due to climate zone (4a) can you model the proposed with economizers if in design and not model economizers in the baseline?

As part of the October 2016 LEED addenda update (http://www.usgbc.org/articles/leed-addenda-update-october-2016), USGBC updated the Water User Reduction Guidance document to Version 9 (http://www.u

Our project serves > 100 meals a day, therefore, Table 3 commercial kitchen equipment applies.

Hello, Would an indoor gym that's at least 25,000 square feet and available to anyone (non members can pay for a day pass) be acceptable?

The requirements do not specify if the school has to be within the project boundary.

Currently working on a job which is under Commercial Interiors v2009. There is an existing concrete floor which is going to be sealed. Which coating type would this need to be classified as?

If an adhesive is used to secure batt insulation, I would think that adhesive also needs to be included in the group 1 section for sealants and adhesives. Is that correct?

Hi, Can anyone has guidelines or suggest for attempting of Innovation in Design credit for Employee Wellness Can it be achieved? or suggest any other alternative. Regards SRIRAM

Can energy modelling and fundamental + enhanced commissioning be done by the same company? Any conflict of interest in such setup?

Hello, I see that the calculator is no longer available in the documentation toolkit on LEED User. Is this available elsewhere as it would be helpful in tracking compliance with this credit.