Post a question or comment
Filter by location
Forum
Topic
Replies
Recent

Pif4 interiors

General forums
posted by  dina salah eldin  on 

Hi everybody, If you just have sections.Pdf file thru the building, can it be used instead of internal elevations while completing PIF4, and what the caption should say then , section showing inter

1
Mon Apr 23, 2012, 1:20 pm

System type and OA input

CS-2009 EAp2:Minimum Energy Performance
posted by  Katherine Ann Resurreccion  on 

Hi Everyone! The project that we're working on will be in a country where the local code requires more outdoor air than 62.1 at most of the zone types.

0

Ceramic Tile, applicable areas for credit compliance

CI-2009 IEQc4.3:Low-Emitting Materials—Flooring Systems
posted by  Tanmay Tathagat  on 

The credit language mentions that "all flooring materials" should comply with this credit requirements.

1
Mon Apr 23, 2012, 1:39 pm

FloorScore Alternative Compliance Path

CI-2009 IEQc4.3:Low-Emitting Materials—Flooring Systems
posted by  Tanmay Tathagat  on 

I am seeking clarity on the alternative compliance for FloorScore certified materials.

1
Mon Apr 23, 2012, 2:01 pm

Conditioned Floor Area

CS-2009 EAc1:Optimize Energy Performance
posted by  Sunil Kumar Anantharaman  on 

G 3.1.1 of Appendix G performance rating method mentions that Base Line building design shall be based on "usage, no.

1
Tue May 8, 2012, 1:27 pm

flashing and trim

NC-2009 SSc7.2:Heat Island Effect—Roof
posted by  Iris Amdur  on 

Are roof flashing and trim included in SSc7.2 calculations?

1
Thu Apr 26, 2012, 4:26 pm

Reused aggregate base on site

NC-2009 MRc4:Recycled Content
posted by  jim bell  on 

Our project in Guam used base material extracted on site and gradated for reuse as aggregate sub-base below slabs and pavement on site.

1
Tue Apr 24, 2012, 5:53 pm

Apartment building - clarify air sealing and weatherstripping

EBOM-2009 IEQp2:Environmental Tobacco Smoke (ETS) Control
posted by  Kimberly Cullinane  on 

I am working with an apartment building that does include some smoking residential units and some nonsmoking units.

1
Tue May 8, 2012, 9:34 pm

C&S Default Occupancy - Unoccupied zones

CS-2009 EAp2:Minimum Energy Performance
posted by  Maya Karkour  on 

Dear all, We're working on a large C&S retail mall.

0

Baseline service water heater

NC-2009 EAp2:Minimum Energy Performance
posted by  Mark Benson  on 

In the proposed design, we are using a water-to-water heat pump for the sole purpose of service water heating. Voltage and Amps are 460v and 140 RLA, respectively.

1
Tue Apr 24, 2012, 3:22 pm