Log in
Forum » NC-v4 EQp1
Loading...
Topic

Ventilation Requirement for High Rise Residential

NC-v4 EQp1: Minimum indoor air quality performance
posted by Jay Murray on Jul 3, 2019, 10:07 am

Question: Is it necesary to hard duct ventilation air into each bedroom within the apartment? Or...is it adequate to provide all of the required ventilation for that apartment in one location (ie...

Required spaces for IEQp1 calculator

NC-v4 EQp1: Minimum indoor air quality performance
posted by Jasmine Abdollahi on Jul 2, 2019, 1:10 pm

Hello, 

I was under the assumption that the IEQp1 calculator should only include densely occupied spaces, but I'm having trouble finding any documentation around which spaces should be...

Last reply: David Hubka, Jul 2, 2019, 2:59 pm

Major renovation to existing building- EQp1 requirements

NC-v4 EQp1: Minimum indoor air quality performance
posted by Navisa Jain on May 23, 2019, 10:25 am

We have a 6 storey addition to an existing 4-storeyed building. The mechanical systems for the addition are separate from the existing systems. The project is going for LEED v4 CS certification...

Last reply: David Posada, May 31, 2019, 4:17 pm

Demand Control Ventilation

NC-v4 EQp1: Minimum indoor air quality performance
posted by Ricardo Sá on May 22, 2019, 7:47 am

Dear All,

I’m currently modelling a building that uses DOAs with air-side heat recovery for space ventilation in the Proposed Design. As per ASHRAE 90.1 – 2010, section 6.4.3.9...

Outdoor air monitoring- Mass balance

NC-v4 EQp1: Minimum indoor air quality performance
posted by Ricardo Sá on May 17, 2019, 6:19 am

Hi,

In what concerns outdoor airflow monitoring requirements for a...

CIBSE Narrow Plan Requirement

NC-v4 EQp1: Minimum indoor air quality performance
posted by NJ on May 9, 2019, 11:25 pm

Hello everyone,

Are there any alternatives for complying CIBSE AM10 requirement for narrow plan? Our project will have a building width that is greater than 15m by almost 4m even with the...

non-attainment area for PM2.5

NC-v4 EQp1: Minimum indoor air quality performance
posted by Francesco Passerini on Feb 24, 2016, 4:28 am

In Europe which parameters shall be considered to establish whether the site is non-attainment area for PM2.5?

Last reply: Maki Watanabe, Apr 12, 2019, 12:51 am

Minimum Indoor air quality compliance procedure- 100% OA AHU with zone level recirculation

NC-v4 EQp1: Minimum indoor air quality performance
posted by Isabel Santos on Mar 15, 2019, 11:11 am

Hello Everyone,

I have an office floor that is conditioned by a Fresh Air handling Unit (100% Outdoor Air) with Heat Recovery and in some enclosed office spaces we have Fan Coil Units (FCU...

Last reply: otto, Mar 22, 2019, 9:43 am

Refrigerated Storage rooms ventilation requirements

NC-v4 EQp1: Minimum indoor air quality performance
posted by Luis Andrade on Feb 1, 2019, 1:12 pm

Hello,

I have a doubt regarding the need to ventilate refrigerated warehouses or storage rooms.

As per Addenda L of ASHRAE 62.1 - 2010, refrigerated strorage rooms with a cooling...

Last reply: David Hubka, Mar 21, 2019, 7:53 am

Airflow monitor alarms

NC-v4 EQp1: Minimum indoor air quality performance
posted by Nancy Henderson on Aug 30, 2018, 1:17 pm

We have several single zone RTU's that will need direct airflow monitors because the units have DCV.  The contractor says the low OA alarm will be located on the units at the roof.  They do not...

Last reply: David Hubka, Mar 19, 2019, 3:52 pm