Does the Architect Signatory have to be a LEED AP? or just a registered Architect?

In our building we have two main AHU that supply 26 AHU (one for each floor of the building) and then we have VAVs for each zone in each floor. Do I need to perform measurements just in the two ma

The Contractor will not be using the HVAC during a minor alteration and there is no HVAC scope except for Air balancing and cleaning of ductwork. How much sealing is required?

Hello everyone - Our project's registration details reference building square footage as 51,441. However, we've only finished 40,100 sqft.

We are working on a college dormitory and trying to calculate the daily uses for kitchen sinks. The only kitchen is on the first floor of the dorm and not in each dorm room.

We have a "zero lot line" LEED project, where the LEED project boundary is essentially the same as the footprint of the building. There is no new parking provided within the LEED boundary.

I am hoping for some guidance on what product category wet/dry vacuums fall into.

If I submit EAc1 in my design review and it gets sent back as likely approved, can I still have the ability to change some things before I submit again for Construction Review?

In EAc1 Related Credits (pg. 260 of BD&C Book) it says that you can mitigate energy use impacts by using renewable energy: refer to EAC2, and EAC6.

I have a project for which we are pursuing Platinum and have an opportunity to use a bio-based material (12"+/-) as a filler under pan deck and concrete.