Log in
Forum » NC-2009 EAp2
Topic

.

NC-2009 EAp2: Minimum Energy Performance
posted by Instra Ingenieros on Jun 27, 2017, 12:17 pm

Wrong question. please delete this comment

Sorry

Exterior lighting not yet designed

NC-2009 EAp2: Minimum Energy Performance
posted by Vassil Vassilev on Jun 27, 2017, 4:20 am

Greetings,
The project we are modeling at the moment is supposed to have exterior lighting for the facades, some parking lots and some walkways.
The exact...

Last reply: Marcus Sheffer, Jun 27, 2017, 10:23 am

Baseline Garage Ventilation

NC-2009 EAp2: Minimum Energy Performance
posted by Vassil Vassilev on Jun 25, 2017, 5:10 am

Greetings,
In our project (registered as per LEEDv2009) there are several garage ventilations.
According to ASHRAE 62.1-2007, the garage exhaust rate is to be sized to 0.75 cfm/ sq.ft...

Last reply: Marcus Sheffer, Jun 26, 2017, 2:43 pm

Baseline Energy Rates for CHP

NC-2009 EAp2: Minimum Energy Performance
posted by Gopinath Vasu on Jun 25, 2017, 8:34 am

I am working on a project where natural gas generator is used power generation and the waste heat is recovered to run the VAM chiller. So, i modeled the generator and VAM chiller as...

Last reply: Marcus Sheffer, Jun 26, 2017, 9:25 am

Energy Rates for CHP used Project

NC-2009 EAp2: Minimum Energy Performance
posted by SAMY Chamy on Jan 28, 2016, 10:12 am

SAMY Chamy Enginneer T&T Green LEEDuser Basic Member 12 thumbs up January 31, 2016- 11:33 pm Awaiting for your reply Log in or register to post comments Tristan Roberts Representative Vermont House of Representatives LEEDuser Expert 11477 thumbs up February 1, 2016- 9:53 am Samy, please see our FAQ on forum etiquette. Thanks! Log in or register to post comments Marcus Sheffer LEED Fellow 7group / Energy Opportunities LEEDuser Expert 5903 thumbs up February 1, 2016- 1:39 pm The rate used for the CHP in the proposed must be identical to the rate used in the baseline. You can't use...

Last reply: Marcus Sheffer, Jun 26, 2017, 9:24 am

Baseline Garage Ventilation

NC-2009 EAp2: Minimum Energy Performance
posted by Vassil Vassilev on Jun 25, 2017, 7:09 am

Greetings,
ASHRAE 62.1-2007 establishes a ventilation exhaust rate for garages of 0.7 cfm/sq.ft.
Our project has lower rate and besides it applies a CO control settings of 20mg/m3....

Baselin Garage Ventilation

NC-2009 EAp2: Minimum Energy Performance
posted by Vassil Vassilev on Jun 25, 2017, 7:08 am

Greetings,
ASHRAE 62.1-2007 establishes a ventilation exhaust rate for garages of 0.7 cfm/sq.ft.
Our project has lower rate and besides it applies a CO control settings of 20mg/m3....

Natural Ventilation modeling question

NC-2009 EAp2: Minimum Energy Performance
posted by Billy Condor on Jun 22, 2017, 7:41 pm

Hello!

An educational building will have no AA for its classroom, workshops and labs (mainly 90% of the project area), as all these areas will be naturally ventilated (complying with...

Baseline Hot water pump power for Purchased heat

NC-2009 EAp2: Minimum Energy Performance
posted by Vassil Vassilev on May 28, 2017, 4:43 am

Greetings,
The project we are modeling follows LEDD v3 - 2007 (System 7) and the heating source is purchased heat. There are two question related to this issue.

1. Is there some...

Last reply: Marcus Sheffer, Jun 21, 2017, 3:54 pm

Water Heater efficiency per table 7.8 of ASHRAE 90.1-2007

NC-2009 EAp2: Minimum Energy Performance
posted by Billy Condor on Jun 19, 2017, 12:51 pm

Hello,
As required by 7.4.2 Equipment Efficiency of ASHRAE 90.1-2007, for a water heater less than 12 kW and more that 20 gal, the required performance is EF=0.97-0.00132*V.
My...