Hi, I know this has been discused before, but I still can´t make it.
The thing is that I have a C&S building to model.
I have assumed 35 W/m2 of other loads on all tennant spaces...

In order to fulfil the requirements of EAp2 through building simulation, do we need to meet mandatory requirements of ASHRAE 90.1 2007. We feel that meeting recommended building envelope U/R...

I have a question about Mandatory provision 6.4.1.1 Equipment efficiency. Our project is a LEED Core and Shell project and a retail centre, 500 000 foot2. The retail centre will be heated and...

Hi all!

I’m modeling a 49-story building with 7 basements, and it has over 40 % (about 85 %) of its envelope covered with glazing, so I have a doubt about the calculation on the Window to...

Our Campus Application CS mixed use/office project uses a common HVAC (district energy) system. The Owner's program required 100 s.f. per ton for the retail areas and 300 s.f. per ton for...

Hi everyone!

If the project...

There is a fan system that will supply outdoor air for the building, This system is a big injection fan that will supply air to all zones that is completed designed and all the zones that are not...

Hi all

We work on a office project at Marseille France with the Leed CS 2009 ; According to
- Table B-3 International Climate Zones Ashrae 90.1 2007 : Marseille / France is located...

Our project proposed to install facade lighting system. They will use a linear tube...

According to ASHRAE 90.1, power allowance for lighting in mall areas is 18 W/m2 (table 9.6.1).
However, according to section 9.6.2 of ASHRAE 90.1, an additional lighting power of 10,8 W/m2...