Forum quick links
Equity & Community Benefits
NC-v4.1 LTc3:High Priority Site and Equitable Developmentposted by Xavier Mora on
Hello,
to obtain the point of this credit, how does it need to be this equity plan? For who do I need to design?
Should we implement to the neighborhood this plan?
Overall credit experience
Pilot-Credits EQpc116:Daylight in nonregularly occupied spacesposted by Valeria Fiorentino on
As the project was already pursuing Daylight credit we have been able to use the same simulation tool for this piot credit.
Hotels-Campus guidance or LEED Interpretation 10203
posted by Ana Milinkovic on
Hello,
EQpc123 Designing with nature
CS-v4 INc1:Innovationposted by Triple Green Building Group on
I have been documenting this as an innovation for a long time, but now attempt it as a pilot credit for a first time due to the requirement to have at least one pilot credit for the total 5 points.
Points relative to Appliance and Process Water
NC-v4 WEc2:Indoor water use reductionposted by Francesco Passerini on
As project team, we are involved in a NC project.
Exhaust rate Table 6.5 ASHRAE 62.1 Clarifications for toilets
NC-v4.1 EQp1:Minimum Indoor Air Quality Performanceposted by Alessandro Zuanon on
Dear all,
some questions about exhaust flow rates to be used for toilets form table 6.5 of ASHRAE 62.1:
Solid wood suspended ceiling slats, which category is this?
NC-v4.1 EQc2:Low-Emitting Materialsposted by Cecilia Lopez-Cotarelo on
Hello,
Outdoor Air when Baseline has System 2
NC-v4 EAp2:Minimum energy performanceposted by Greenlab on
I am following v4 and ASHRAE 90.1 - 2016.
I have an Hotel in Climate Zone 3A, therefore I am using System 2 (PTHP) for Baseline.
LEED project boundary
CS-v4 MPR2:Must use reasonable LEED boundariesposted by Francesco Passerini on
The site area of our project has some differences between ground floor and the basement: the basement area is higher than the ground floor area.
Luminance of less than 2,500 cd/m2 between 45 and 90 degrees from nadir
NC-v4 EQc6:Interior lightingposted by Henri Barten on
Hello, i'm new into the LEED requirements.
My customer ask me if we have light fixtures with a luminance of less than 2,500 cd/m2 between 45 and 90 degrees from nadir.