Dear sir/madam, Per the Revised Section 1 4 Tables (Dec 2012), for Systems 9 and 10,the fan power=0.3*supply air flow rate(cfm).

This is with regard to an open air shopping plaza, which is registered as a group project with 7 structures. We received guidance to follow the “Treatment of District or Campus Thermal Energy in

I understand the selection of the base building systems (number of floors, sf, etc.) My question is, if the packaged RTU's are gas fired heat, but the fan powered VAV boxes (in the proposed design

Hi, We are working on a core and shell project. While filling minimum energy performance calculator table we met with some issues.

I am not clear about explanation from ASHRAE 90.1-2007 User’s Manual: 1. For laboratory spaces with a min.

Good afternoon, My company is developing a LEED Core and Shell evaluation of a warehouse that does not have any climatization systems (it is considered "Unconditioned" because it has a very low pe

I’m working on a Core & Shell project that has as Energy source a District Heating that use only heat recovery from combustion of municipal solid waste, I would like to know if the compliance p

Hi, Hi, in EU most countries have feed-in-tarriffs, which reimburse the owner for energy produced at a higher rate than the cost of energy.

On a C&S healthcare building, we simulated the receptacle load based on CS Appendix 2, Table 1, as the appendix directed.

In a LEED CS 2009 building energy simulation we are modeling the building envelope to test performance (only the building envelope).