Hi, I'm modeling a building (not residential),for EAc1, located in climate zone 6 (winter design temperature 5°F).

We have a project that is a mix-used 23,000 SF bldg. The lower story is commercial (8,000 SF) and 2-stories of residential (15,000 SF).

Hello all, One of our CI project will be using the blinds with Graphic prints. My question is if the ink needs to comply with any of IEQ requirements? Any guidance would be greatly appreciated.

I’m working on a Project in Portugal, which consists in a 13.400m2 site, with 6000m2 rooftop (harvests rain), 2500m2 green roof, 2735m2 of gardens, 306 m2 of planters and 1840m2 of impermeable pave

We have a library project that is reusing metal shelving. Since it is being used for the same purpose this credit indicates it should be part of MR1.2.

I'm working on (a renovation of) an existing church with 6 FTE, and 400 peak transients. 5% of 406 FTE = 20 bicycle parking spaces.

I am modeling a LEED building that includes a snow melt system. The system is served by the building's hot water boiler.

Thanks for all descriptions and comments related to differences beween EAp1 and EAc3. I`m still confused about Exemplary Performance and it`s "comprehensive envelope commissioning".

Hello all, I would kindly ask for an information please. My HVAC multizone system, looks like this. VAV AHU system (with sensible heat recovery, no mixing) + Fan Coil Units (FCU).

In our project we intend to install PV panels for 300KWp capacity. Its a NC2009 project aiming for LEED platinum. The building is office building with a 24hrs cafeteria.