at different flow rates, then the answere is beyond the scope of this forum (hint: the flow impacts on the hydronic pressure that the fan must overcome in the system and directly impacts the power...check out your software's user forum). Log in or register to post comments Marcus Sheffer LEED Fellow 7group / Energy Opportunities LEEDuser Expert 5903 thumbs up October 20, 2014- 7:13 am Appendix G requires...

Hi!
We are trying to offset as much as possible from our electricity consumption with on-site PV. We will install about 750 m2 of PV, of these 750 m2 PV only 500 can be placed on site and...

According to 5.4.3.4 (mandatory provision) enclosed vestibules shall protect building entrances that separate the conditioned space from the exterior. In the building that I’m considering, a...

Hi everyone,

It is necessary to prove the power...

The project I'm working on currently is for a production plant and office zones all in one building. There is no cooling coils in all designed system with the exception of the Dx unit in the...

Hi Marcus et al.,

I received a question from one of our project energy modelers that I cannot answer -

Recently we have been receiving a new comment on EAp2 that states
“...

Hi everyone! I've some doubts about this points.

Whats is the setback temperatures?

The time setpoint not met is calculated only in the occupied hours? I ask this because the air...

I'm considering a "Multi-purpose indoor unit for use in 4-pipe systems for the simultaneous production of chilled and hot water by means of two independent water circuits". The unit transfers...

Hi,
I am working on a dining facility where we have two makeup air units serving the kitchen hoods. The units in the proposed case are equipped with chilled water coils served with the...

Hello.

One review comments that i have received about E&Ap2 prerequisite is:

2. No exterior lighting power has been modeled for the Baseline or Proposed Case. Confirm that no...