I have a technical question about LEED Online and inputting information into the Adobe Form for IEQp1.

I have a 3 story non-residential building, and VAV's on each floor are served by individual air handling units.

Our project has one primary ventilation system for the entire project space served by the base building AHUs.

Our project is primarily naturally ventilated and meets the requirements of Section 5.1 in non-core areas.

We have a central Air Handling Unit supplying 100% outside fresh air to all the rooms in a building, e.g offices, meeting rooms, conference rooms, etc This air will be tempered to say 18 degrees Ce

We received a comment back on a CI project stating: "Demonstrate the system serving the special occupancy space is capable of modulating system and zone minimum supply volume below 0.30 cubic feet

We have a small mechanical equipment room that contains a backup diesel generator. It is being ventilated to remove exhaust and excess heat.

For ASHRAE 62.1 do I upload forms for the Baseline of meeting ASHRAE 62.1 and not my forms for IEQc2 Increased Ventilation? Table IEQp1-3.

How to provide a narrative to explain how the worst-case condition was determined considering the total design airflow rate at the condition analyzed