Forum discussion
CS-2009 EAp2: Minimum Energy Performance
Hello,
This credit requires us to comply with the U-values prescribed by ASHRAE Standard 90.1-2007.
Our project has a Glass skylight covering more than 5% of the roof. The U-values prescribed by ASHRAE are only for skylights covering from 0% to 2% of the roof or 2.1% to 5% of the roof.
As such, could anybody tell me what are the U-values requirements for glass skylight with curbs covering more than 5 % of the roof ?
What about glass skylight without curb ?
Thank you for your help.
LEEDuser is supported by our premium members, not by advertisers.
Go premium forTo post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.
A portion of our building envelope is historic. Can we exclude it from our model?
For an existing building, do I need to rotate the model?
Our process load is higher than 25%. Do we have to justify that?
Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?
Can mezzanines open to floors below be excluded from the energy model?
How do I provide a zip code for an international location?
For a project outside the U.S., how do I determine the climate zone?
For a project outside the U.S., how do I determine the Target Finder score?
Do hotel rooms need automatic light shut-off control?
How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?
The Section 9 space-by-space method does not include residential space types. What should I use?
Can the Passive House Planning Package (PHPP) be used to energy model for LEED?
Which baseline HVAC system do I use if my building has no heating or air conditioning?
Our project has a diesel backup generator. Should we include it in our energy model?
Can SHGC be higher in the proposed than in the baseline model?
Tristan Roberts
RepresentativeVermont House of Representatives
LEEDuser Expert
11477 thumbs up
April 1, 2010 - 8:48 am
George, I think this question has been answered in a comment by Roger Chang over on the NC EAp2 page. In short, demonstrate compliance either with a trade-off or a whole-building energy simulation.