Forum discussion

NC-2009 EAc4: Enhanced Refrigerant Management

See LEEDuser’s guidance on NC-2009 EAc4 »

Tonnage Associated with Energy Recovery Equipment

September 19, 2011

Rebekah Burke

Clark Nexsen

LEEDuser Basic Member

31 thumbs up

September 19, 2011

Is the tonnage requirement for the credit supposed to include compressor capacity only or can additional capacity from energy recovery devices be included in the tonnage?

Post a reply

Tristan Roberts

Representative
Vermont House of Representatives

LEEDuser Expert

11477 thumbs up

November 19, 2011 - 11:26 pm

Rebekah, I believe tonnage would include the whole system capacity.

Log in or register to post comments

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.

See all forum discussions about NC-2009 EAc4

Subscribe to new posts about NC-2009 EAc4

Post a new question about NC-2009 EAc4

See LEEDuser’s guidance on NC-2009 EAc4 »

FAQs about EAc4:

We plan on pursuing this credit only if we need to do so to meet our certification target, i.e. if another credit we are counting on gets rejected. How late can we apply for this credit?

I'm working on a renovation project and we'll be keeping some of the existing equipment. Shoud we include these systems in our calculations?

Which portions of a VRF/VRV system should be considered for this credit? 

For a split system, does the cooling capacity refer to the cooling power of the interior device (evaporator) or of the outdoor unit (condenser)?

What is the required timeline for completing a CFC phase-out for EAc4?

How can I document a longer equipment life (20 or 30 years) than what is listed in the LEED Reference Guide?

Do the requirements apply to portable fire extinguishers or only permanently installed building-wide fire suppression systems?

View answers »