See all forum discussions about NC-2009 WEc3

Subscribe to new posts about NC-2009 WEc3 Post a new question aboutNC-2009 WEc3

See LEEDuser’s guidance on NC-2009 WEc3»

FAQs about WEc3 :

Will the reviewers accept a spreadsheet as a plumbing fixture schedule in lieu of the plans from the Construction Documents?

In LEED review comments I've been referred to the Water Use Reduction Additional Guidance document. I didn't know this was a required reference document.

Should I include bar sinks? What about mop sinks or janitor sinks? Swimming pools? Safety showers? Bidets? Tub spouts?

We provided new showers in our project to comply with the alternative transportation credit. Should they be considered in WEp1 calculations?

Can you explain the 12-second duration for metering faucets?

Can I use a nonpotable water source to contribute to WEp1 compliance?

Our project does not have any eligible water fixtures in the project boundary. Can we comply with WEp1?

We are having trouble finding EPAct-compliant fixtures. Is that a problem?

Where can I find a clear meaning of "public" and "private" as relevant to lavatory faucets?

Our project is a factory with historically a 95% male workforce. The restroom design accounts for this. Can I argue that the male/female gender ratio is different than 50/50?

Are shower duration controls an acceptable water-saving strategy?

Can I include process water savings in order to earn an Exemplary Performance point?

View answers »

Forum discussion

NC-2009 WEc3:Water Use Reduction

29.47% reduction question...

Rick Alfandre

Principal

Alfandre Architecture

LEEDuser Basic Member

13 thumbs up

November 20, 2013

We had an initial mis-characterization of our flow fixtures (we thought they were private, not public), and now with everything properly calculated we are at 29.47% reduction from base case. Are there any measure to accompany this percentage which might push us up to 30%

Post a reply

Tristan Roberts

Representative

Vermont House of Representatives

LEEDuser Expert

7780 thumbs up

Fri, 12/20/2013 - 21:03

Rick, I'm not sure exactly what you're asking. However, rounding up in this case would not be allowed, so you'll need to adjust your strategies (or your calculations, if defensible) to earn the credit.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.