See all forum discussions about NC-2009 WEp1
 Subscribe to new posts about NC-2009 WEp1 Post a new question aboutNC-2009 WEp1
See LEEDuser’s guidance on NC-2009 WEp1»
FAQs about WEp1 :

Will the reviewers accept a spreadsheet as a plumbing fixture schedule in lieu of the plans from the Construction Documents?

In LEED review comments I've been referred to the Water Use Reduction Additional Guidance document. I didn't know this was a required reference document.

Should I include bar sinks? What about mop sinks or janitor sinks? Swimming pools? Safety showers? Bidets? Tub spouts?

We provided new showers in our project to comply with the alternative transportation credit. Should they be considered in WEp1 calculations?

Can you explain the 12-second duration for metering faucets?

Can I use a nonpotable water source to contribute to WEp1 compliance?

Our project does not have any eligible water fixtures in the project boundary. Can we comply with WEp1?

We are having trouble finding EPAct-compliant fixtures. Is that a problem?

Where can I find a clear meaning of "public" and "private" as relevant to lavatory faucets?

Our project is a factory with historically a 95% male workforce. The restroom design accounts for this. Can I argue that the male/female gender ratio is different than 50/50?

Are shower duration controls an acceptable water-saving strategy?

Can I include process water savings in order to earn an Exemplary Performance point?

View answers »

Forum discussion

NC-2009 WEp1:Water Use Reduction—20% Reduction

Dual Showerheads

We have a hotel where the showers have two showerheads. One showerhead placed overhead and one han-held showerhead. They have different flow-data. Both showerheads will be used, but we do not know how much each of the showerheads will be used. Which flow data shall we use? The highest flow or the average flow, or?

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Mon, 06/15/2015 - 11:46

I believe you need to use the worst-case scenario (the highest flow rate). Along those lines, if they can be used simultaneously, I believe you'll need to add the two rates together...

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.