See all forum discussions about CS-2009 EAc5.1
 Subscribe to new posts about CS-2009 EAc5.1 Post a new question aboutCS-2009 EAc5.1
See LEEDuser’s guidance on CS-2009 EAc5.1»
FAQs about EAc5.1 :

How can I choose between Option 1 (Calibrated Simulation) and Option 2 (Energy Conservation Measure Isolation)?

What am I required to submeter for this credit?

View answers »

Forum discussion

CS-2009 EAc5.1:Measurement and Verification—Base Building

List energy end uses

Default Avatar
Mike D
LEEDuser Basic Member
45 thumbs up

"The M and V Plan omits the table or listing of the project’s energy end uses as required by the form." However, the Plan we have submitted lists the following: Locations and types of energy meters are shown on drawing 10610/35008. The following energy types are metered: Electricity LTHW Chilled water Domestic water Softened Water Gas Is there any additional details that need to be listed regarding the energy end uses?

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user sheffer
Marcus Sheffer
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up

Tue, 06/18/2013 - 13:55

Energy end uses are not the same as energy sources. Energy end uses are typically interior lighting, exterior lighting, space heating, space cooling, fans, pumps, service hot water, plug loads, elevators, etc. You cannot properly calibrate an energy model using just metered energy sources.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.