We have a building where there is a revolving door flanked by two hinge doors. There are mats covering the entire width both outside (covered), and inside at 5' each, for a total of 10' in length. However, the revolving door in the middle does not allow for a circular mat to be installed because of clearance issues. Would this configuration be ok as is, or will additional length need to be added to either the outdoor or interior mats for compliance?

Post a reply

Trista Brown

Project Director

WSP USA

LEEDuser Basic Member

381 thumbs up

Wed, 02/13/2013 - 16:12

Hi Jean, This sounds like an acceptable approach. One word of caution is that appropriate cleaning activities should be in place for the exterior mats, since they're exposed to more weather and particulates than interior mats, even when covered. There are a couple of relevant FAQs above that can provide additional information and direct you to some LEED Interpretations that may be worth checking out. Thanks, Trista

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.

You are currently logged in under an enterprise account

FAQs about IEQc3.5 :

10' mat requirement with revolving door

You rely on LEEDuser. Can we rely on you?

Add new comment