We have a building where there is a revolving door flanked by two hinge doors. There are mats covering the entire width both outside (covered), and inside at 5' each, for a total of 10' in length. However, the revolving door in the middle does not allow for a circular mat to be installed because of clearance issues.
Would this configuration be ok as is, or will additional length need to be added to either the outdoor or interior mats for compliance?
Trista Brown
Project DirectorWSP USA
456 thumbs up
February 13, 2013 - 11:12 am
Hi Jean,
This sounds like an acceptable approach. One word of caution is that appropriate cleaning activities should be in place for the exterior mats, since they're exposed to more weather and particulates than interior mats, even when covered. There are a couple of relevant FAQs above that can provide additional information and direct you to some LEED Interpretations that may be worth checking out.
Thanks,
Trista