See all forum discussions about NC-2009 EAp2

Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2

See LEEDuser’s guidance on NC-2009 EAp2»

FAQs about EAp2 :

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

The Section 9 space-by-space method does not include residential space types. What should I use?

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

Can I claim exterior lighting savings for canopy lighting even though a baseline model cannot include shading elements?

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

Performance Requirements for Water Heating Equipment

Oliver Lange

Senior Consultant

Drees & Sommer SE

LEEDuser Basic Member

1 thumbs up

June 28, 2012

Hello, our project has 40 electrical table top water heaters. The electrical input is 2 kW and 5 liter storage. What is the right way for modeling the baseline builing water heating equipment? Because Table 7.8 (ASHRAE 90.1 2007) says nothing about Water heaters with storage lower then 75,7 liter. It is necessary to sum all inputs and benchmark it with the values in the table?

Post a reply

Jean Marais

b.i.g. Bechtold DesignBuilder Expert

LEEDuser Basic Member

581 thumbs up

Fri, 06/29/2012 - 06:13

I've got the same problem...I've been assuming that there is no requirements for this type of water heater (electric resistance < 12kW or < 75 L) There's a footnote c which I can't find in the table...probably as I'm using the SI addition. I'm thinking that maybe it is considered as an instantaneous water heater with a small unfired storage tank, but then that refers to gas...not electric.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.