See all forum discussions about
Subscribe to new posts about Post a new question about

Forum discussion

SSc6.1 Post-development & Pre-development rate

2
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user greg.hurst
Gregory Hurst
Office Manager
Robert Peccia & Associates
LEEDuser Basic Member
42 thumbs up

Wed, 10/13/2010 - 16:42

My inital thought is that you are infiltrating the entire volume within your LEED boundary (I assume) and if this is the case, then your run-off flow rate is also zero. You only need to measure the rate and volume as it leaves your site.

Wed, 10/13/2010 - 16:59

Gregory, Thank you for the response. That was what we decided to do until we heard opinions otherwise. Our Post-development Rate and Quantity are now set to zero. The form allowed this and allowed us the point.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.