we are a GC working on a project that is the renovation of a historic bldg and that renovation started a very long time ago '(about 3 yrs ago) and about a year before the project was registered for

We have the following materials called out in the 03 30 00 Cast-in place concrete spec: 1. Semi-rigid joint filler 2. Bonding Agent 3.

I am at a loss for the comments made by our LEED reviewer about an aerosol adhesive. The product is a general purpose mist spray aerosol adhesive with a VOC content of 53.2% by weight.

Hello. Would Masonry joint sealant fall in under the "Other" category for a VOC limit of 420 g/L?

What is VOC limit for "Thread Cutting Oils" as per SCAQMD Standards to comply with LEED requirements ?

Hai, my project use epoxy glue for anchoring rebar from brick wall to column and slab in indoor area. Does it must meet LEED requirement for adhesive and sealant?

I am working on a project where we need to provide RF Shielding and are looking for how to adhere a copper sheet below an epoxy floor. The manufacturer recommends a bonding agent that is "

I recently stumbled upon a strange requirement for aerosol adhesives in the IEQ c4.1 credit form v2009 that is NOT listed in the addenda.

I have some sealants and adhesives that are being submitted under Division 06 and 12. Should they just be listed once on the LEED form chart?