My project does not comply with section 1.9A (minimum compliance requirements for process energy modeling) so I need to upload a narrative.

We have a existing building that is LEED Silver and we are adding to same building. New addition is also LEED Silver. Do I need to model both existing and new addition or only new addition.

Does anyone out there know what the following comment pertains to: Provide additional information (Mech-5C report) to verify that the Proposed Case Carrier units have been modeled at a 50% minimum

In this Table, are we supposed to list EVERY room in the building, or group similar rooms to together?

If we are not knowing existing assembly values can we go with ASHRAE 90.1 values for existing assembly. USGBC will approve ?

Does anyone out there know what the following comment pertains to: Provide additional information (Mech-5C report) to verify that the Proposed Case Carrier units have been modeled at a 50% minimum

Following requirement is stated even in the LEED 2009 School Alternative compliances path for project outside the U.S.(July 2012) "The project must establish an energy performance rating goal for

In an all-electric building with a Geothermal Bore field and packaged Heat Pumps system, if the project wants to use an Indirect Gas fired Make-Up Air Unit for the Kitchen Exhaust Hood, will we hav

when the frame effects are captured within the energy modeling software option the output results for vertical glazing assembly U value will vary based on window size.