See all forum discussions about EBOM-v4.1 EQp1
 Subscribe to new posts about EBOM-v4.1 EQp1 Post a new question aboutEBOM-v4.1 EQp1
See LEEDuser’s guidance on EBOM-v4.1 EQp1»
FAQs about EQp1 :

We have a VAV system where single AHUs serve multiple zones. Do we need to take outside air measurements at each VAV box?

Our building has a single fan that supplies outside air to multiple AHUs. Do we need to perform outside air testing at the supply fan or at all AHUs?

What if after our Preliminary Review we have to revise the ventilation rate procedure calculations and find that we need to make corrections to the system in order to meet the prerequisite? Can we redo the outside air testing after making corrections?

My building has 80 AHUs providing ventilation to building spaces. Do I have to do the ventilation calculations and conduct outdoor air measurements for each one?

Our system cannot provide enough outdoor air due to design limitations. What should we do?

What if our systems do not meet the required outside air when systems are tested at worst-case conditions?

The outdoor air intake for our ventilation system is not accessible, and it’s not possible to measure the outdoor airflow directly. How can we determine the outdoor airflow for this system?

How do I find whether my project is located in a non-attainment area for particulate matter or exceeds the prerequisite ozone requirements?

View answers »

Forum discussion

EBOM-v4.1 EQp1:Minimum Indoor Air Quality

Ventilation strategy in a warehouse area

Hi all,

We'll take natutal ventilation in warehouse area however doesn't meet maximum distance.

And mechanical ventilation is too low min. OA, because under 10 peoples are there.

Is it avaliable in take too lower OA in large warehouse area by mechanical ventilation equipment? or another method to demonstrate EQp1 in large warehouse area by natural ventailation?

Thanks,

 

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.