See all forum discussions about NC-2009 EAp2
 Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2
See LEEDuser’s guidance on NC-2009 EAp2»
FAQs about EAp2 :

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

For a project outside the U.S., how do I determine the climate zone?

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

The Section 9 space-by-space method does not include residential space types. What should I use?

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

v2009_Minimum Energy Performance Calculator_v06

Hi All, I am working on a LEED NC 2009 project and have questions about filling up the v2009_Minimum Energy Performance Calculator_v06. Hope someone can give me some advice. Thanks. 1) In the 'Air-side HVAC' sheet, there is one parameter called Total heating capacity. I wonder if this number should be the same as the Total boiler capacity in the 'Water-side HVAC', if boiler is the only heat source. 2) Is it acceptable or normal for proposed model to have higher heating capacity than the baseline model? As the designed boiler capacity was oversized a lot. Thanks.

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user sheffer
Marcus Sheffer
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up

Wed, 02/15/2017 - 15:00

1. That would be the heating capacity for any unitary equipment and the coils in the air side equipment. The boiler capacity would not be expected to match this value, it could be higher of lower. 2.It is not necessarily normal but it could be acceptable. Providing an explanation for these kinds of anomalies is always very helpful to the reviewer.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.