Which one from the table that suits for Synthetic Gloss Enamel paint, that use for painting metals?
You rely on LEEDuser. Can we rely on you?
LEEDuser is supported by our premium members, not by advertisers.
Go premium forForum discussion
NC-2009 IEQc4.2: Low-Emitting Materials—Paints and Coatings
See LEEDuser’s guidance on NC-2009 IEQc4.2 »
Synthetic Enamel's VOC
Add new comment
To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.
See all forum discussions about NC-2009 IEQc4.2
Subscribe to new posts about NC-2009 IEQc4.2
Post a new question about NC-2009 IEQc4.2
See LEEDuser’s guidance on NC-2009 IEQc4.2 »
John-David Hutchison, LEED AP BD+C, PMP
Sustainability ManagerBGIS
LEEDuser Expert
166 thumbs up
February 11, 2015 - 8:29 am
I would say Industrial Maintenance Coatings - Max. VOC 250
Jon Clifford
LEED-AP BD+CGREENSQUARE
LEEDuser Expert
327 thumbs up
February 11, 2015 - 11:14 pm
The paint only qualifies as an Industrial Maintenance Coating if it is formulated to resist extreme environmental conditions such as immersion in water, wastewater, or chemicals; chronic exposure to moisture condensation; exposure to corrosive, caustic or acidic agents or fumes; repeated exposure to extreme temperatures; repeated heavy abrasion, mechanical wear, scrubbing, or industrial cleaners; or exterior exposure of metal structures.
If the paint is formulated for application to steel and simply to resist rust under normal conditions, it is an anti-corrosive/anti-rust paint, also with a VOC limit of 250g/L.
However, some Synthetic Gloss Enamels are formulated as general-purpose paints not just for steel, but for wood, masonry, or other substrates. If this is the case, the Gloss Enamel is a Non-Flat Paint with a VOC limit of only 150g/L.
Yodi Danusastro
February 11, 2015 - 11:28 pm
Thank you very much for the answer :)