See all forum discussions about NC-v4 EAp2
 Subscribe to new posts about NC-v4 EAp2 Post a new question aboutNC-v4 EAp2
See LEEDuser’s guidance on NC-v4 EAp2»
FAQs about EAp2 :

Do the required savings for this prerequisite (and credit) need to come only from building energy, or also process loads?

Our project doesn't have enough energy savings to earn the prerequisite. Can we get there by incorporating onsite renewables?

Our proposed design has insulation R-values that are below those prescribed by ASHRAE 90.1-2010. Can we still meet the prerequisite?

View answers »

Forum discussion

NC-v4 EAp2:Minimum energy performance

Newbie Looking for guidance on completing the Minimum Energy Performance Calculator

Q: Where do I find the Equivalent Full Load Hours of Operations Per Year values to put in the corresponding cells, such as for Interior Light, Service Water Heating, etc...to place on the Schedules tab?

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user sheffer
Marcus Sheffer
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up

Fri, 01/22/2021 - 23:07

This is calculated by dividing the kWh/year by the demand (kW). This leaves hours/year. Where you might find this will vary depending on the software used.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.