See all forum discussions about NC-2009 MRc7

Subscribe to new posts about NC-2009 MRc7 Post a new question aboutNC-2009 MRc7

See LEEDuser’s guidance on NC-2009 MRc7»

FAQs about MRc7 :

Is there a minimum quantity of wood that must be used on the project to qualify for this credit?

We are pursuing IEQc4.5 from LEED-CI as an ID credit. Are we then required to include the cost of furniture in MRc3–7?

What building components are typically purchased with FSC content to earn this credit?

We’re having trouble getting FSC wood within our budget. Can we use products with another forestry certification?

Do I need to provide invoices for all of the new wood products purchased for the project, or just FSC wood products?

I have supporting manufacturer documentation for the FSC wood used on our project. Is this enough to document this credit, or do I need invoices as well?

Can products labeled “FSC Recycled” or “FSC Recycled Credit” contribute towards MRc7? What about "FSC Mix" percentages that refer to recycled content?

Does FSC-certified wood automatically contribute to IEQc4.4 as a low-emitting material?

We are using a lot of reclaimed wood. Should we include this in our MRc7 calculations? What about wood that is already installed on the project, in a renovation? What about wood products with recycled content?

Does FSC-certified bamboo products count towards this credit?

A product has FSC-certified veneer, but a non-certified core. Can we prorate the MRc7 contribution of this product based on the cost of the veneer?

Should wood used on site features such as benches or a gazebo be included here?

View answers »

Forum discussion

NC-2009 MRc7:Certified Wood

Millwork as a whole vs. each piece

Caro Wilbanks

lauckgroup

LEEDuser Basic Member

7 thumbs up

October 18, 2012

We have been denied the MR7 point on a couple of jobs becuase of the millwork documentation. I enter each piece onto the Materials and Resources spreadsheet/calculator as the millworker reports them so that I can document recycled content, regional materials, etc. However the reviewer wants me to show the millwork (which was assembled onsite) as one items with the millworkers COC # which I have. However if I enter this whole number along then I can't enter the pieces individually or it will mess up my calculations for the other credits. Has anyone else run into this?

Post a reply

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.