See all forum discussions about Healthcare-v2009 IEQc4
 Subscribe to new posts about Healthcare-v2009 IEQc4 Post a new question aboutHealthcare-v2009 IEQc4
See LEEDuser’s guidance on Healthcare-v2009 IEQc4»

Forum discussion

Healthcare-v2009 IEQc4:Low-emitting materials

Linear Metal Ceiling

Does a linear metal ceiling product have to comply with the testing and product requirements of California Department of Public Health Standard Method for the Testing and Evaluation of Volatile Organic Chemical Emissions from Indoor Sources Using Environmental Chambers version 1.1 (CDPH/EHLB Standard Method v1.1) modeled using the standard office building protocol parameters and certified as compliant by an independent third party? Does GBCI consider it a ceiling tile or suspended acoustical tile?

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Tue, 10/08/2013 - 18:02

I wonder about this for metals in general, like metal studs. I'd like to see a clarification.

Tue, 10/08/2013 - 19:59

What is your gut feeling? I have to make a determination as to whether a specific product is acceptable or not. It has not been tested in accordance with CDPH/EHLB Standard Method v1.1. Thanks again for responding! I really appreciate it. 8-)

Tue, 10/08/2013 - 20:21

My gut says that metals don't off gas and don't need to be tested. But the scoping paragraph or CDPH/EHLB states the following: "This method applies to any product category generally used within the envelope of an enclosed indoor environment. The method is applicable to products that can be tested whole or by representative sample in environmental chambers. This includes, as examples, paints, other architectural coatings and finishes, sealants, adhesives, wallcoverings, floor coverings, acoustical ceilings, wood paneling, wall and ceiling insulation used in public and commercial office buildings, schools, residences and other building types." It also applies to free standing furniture and it very clearly states that structural items do not apply.

Tue, 10/08/2013 - 21:49

Thanks. I looked up the test method information to refresh my memory. The product I have is going to be installed at the exterior roof soffits, not inside the building, which is not located "within the envelope of an enclosed indoor environment." So I think I'm all set on this one!!

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.