See all forum discussions about NC-v4 EAp2
 Subscribe to new posts about NC-v4 EAp2 Post a new question aboutNC-v4 EAp2
See LEEDuser’s guidance on NC-v4 EAp2»
FAQs about EAp2 :

Do the required savings for this prerequisite (and credit) need to come only from building energy, or also process loads?

Our project doesn't have enough energy savings to earn the prerequisite. Can we get there by incorporating onsite renewables?

Our proposed design has insulation R-values that are below those prescribed by ASHRAE 90.1-2010. Can we still meet the prerequisite?

View answers »

Forum discussion

NC-v4 EAp2:Minimum energy performance

Lighting Power Density for sauna

What shall I consider as Lighting Power Density (TABLE 9.6.1 of ASHRAE 90.1-2010) for a sauna that is inside a hotel?

Best Regards

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user sheffer
Marcus Sheffer
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up

Wed, 01/22/2020 - 16:37

Which area type in the table is the closest fit?

Thu, 01/23/2020 - 08:42

Maybe Fitness Area (7.8 W/m2)?
Profile picture for user sheffer
Marcus Sheffer
LEED Fellow
7group / Energy Opportunities
LEEDuser Expert
4454 thumbs up

Thu, 01/23/2020 - 18:00

Seems like a fitness area needs more light than a sauna. If there is not a good fit then you could consider it a process load and model it identically. This would be the conservative approach.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.