Forum discussion
NC-2009 EAp2: Minimum Energy Performance
We are working in a project that has a gas-fired boiler that supplies hot water for space heating (radiant floor) and domestic hot water.
Do we need to comply with efficiencies in tables 6.8.1F and 7.8? Or would it be enough just compling with table 6.8.1F?
Thanks in advance.
LEEDuser is supported by our premium members, not by advertisers.
Go premium forTo post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.
A portion of our building envelope is historic. Can we exclude it from our model?
For an existing building, do I need to rotate the model?
Our process load is higher than 25%. Do we have to justify that?
Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?
Can mezzanines open to floors below be excluded from the energy model?
How do I provide a zip code for an international location?
For a project outside the U.S., how do I determine the climate zone?
For a project outside the U.S., how do I determine the Target Finder score?
Do hotel rooms need automatic light shut-off control?
How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?
The Section 9 space-by-space method does not include residential space types. What should I use?
Can the Passive House Planning Package (PHPP) be used to energy model for LEED?
Which baseline HVAC system do I use if my building has no heating or air conditioning?
Our project has a diesel backup generator. Should we include it in our energy model?
Can SHGC be higher in the proposed than in the baseline model?
Marcus Sheffer
LEED Fellow7group / Energy Opportunities
LEEDuser Expert
5909 thumbs up
March 27, 2015 - 1:23 pm
Both.
See Table G3.1-11 Baseline (e) for the Baseline requirements.
CT G
23 thumbs up
March 27, 2015 - 2:11 pm
Thank you, Markus.
Now that I read my question again I see that I wasn't clear.
What I would like to know is to comply with sections 6.4 and 7.4, therefore with this prerrequisite, does the efficiency of my boiler have to be greater than the values expressed on table 6.8.7F and 7.8? Or just for the one of the tables?
Marcus Sheffer
LEED Fellow7group / Energy Opportunities
LEEDuser Expert
5909 thumbs up
March 27, 2015 - 2:27 pm
Yes greater than both. The minimum efficiencies are likely to be very similar in both anyway.