See all forum discussions about NC-2009 EAp2

Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2

See LEEDuser’s guidance on NC-2009 EAp2»

FAQs about EAp2 :

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

The Section 9 space-by-space method does not include residential space types. What should I use?

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

Can I claim exterior lighting savings for canopy lighting even though a baseline model cannot include shading elements?

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

Exterior Radiant Heaters

Seth Penchansky

Architect

Daniels and Zermack Architects

LEEDuser Premium Member

0 thumbs up

February 14, 2014

We are considering LEED certification for a four season golf range hitting facility that will have hitting areas with overhead radiant heaters and indoor conditioned areas as well. I assume we need to include the radiant heaters in our entire energy model and make improvements in the control and efficiency of the radiant to show at least a 10% energy savings since the indoor areas will consume less energy than the outdoor areas. Does anyone have any similar experience that would be helpful?

Post a reply

Marcus Sheffer

LEED Fellow

7group / Energy Opportunities

LEEDuser Expert

4454 thumbs up

Mon, 02/17/2014 - 16:17

The outdoor heaters would be considered a process load and must be modeled identically in both models. Any savings would need to be claimed as an exceptional calculation. I suppose if there were more efficient radiant heater you could claim some savings but in my experience the efficiencies are all pretty much the same.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.