if actual Rc (lb/ton) of the chiller and other refrigerant units are unknown then will i able to take default.
You rely on LEEDuser. Can we rely on you?
LEEDuser is supported by our premium members, not by advertisers.
Go premium forForum discussion
EBOM-2009 EAp3: Fundamental Refrigerant Management
See LEEDuser’s guidance on EBOM-2009 EAp3 »
Enhanced Refrigerant Management
Add new comment
To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.
Levi Jimenez
Founder & Senior ConsultantViable LLC
12 thumbs up
May 6, 2016 - 2:30 pm
Vishesh,
In my project experience, it has been acceptable to use the default values as listed in the reference guide. When in doubt, use conservative worst-case values. This credit is too often shrouded in mystery, but can easily be embraced and earned when enough is known about the equipment.