Forum discussion

NC-2009 IEQc4.1: Low-Emitting Materials—Adhesives and Sealants

See LEEDuser’s guidance on NC-2009 IEQc4.1 »

Duct Seal level

Project location: United Arab Emirates

December 10, 2015

Sarfaraj Khan

Commissioning & Sustainability Consultant
Green Consulting

LEEDuser Basic Member

Project location: United Arab Emirates

December 10, 2015

Minimum duct seal level must comply with table 6.4.4.2A- Ashrae 90, i have this in my specification for duct and i think it apply only to G.I Duct, Not to pre insulated duct, please anyone can clarify this

Post a reply

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.

See all forum discussions about NC-2009 IEQc4.1

Subscribe to new posts about NC-2009 IEQc4.1

Post a new question about NC-2009 IEQc4.1

See LEEDuser’s guidance on NC-2009 IEQc4.1 »

FAQs about IEQc4.1:

Is there a shortcut to the VOC budget method if you have just one product that is used minimally on a project?

Do products applied to the weather barrier need to comply with VOC thresholds?

How do I determine what application my product falls under?

How is VOC % less water determined for aerosol adhesives?

Do grout and caulking need to be included, and if so, what is the application category?

Our project didn't use some common adhesive types, and our LEED reviewer asked about this. Are we supposed to justify not using certain adhesives in our documentation?

View answers »