See all forum discussions about NC-2009 EAp2

Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2

See LEEDuser’s guidance on NC-2009 EAp2»

FAQs about EAp2 :

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

Can I claim exterior lighting savings for canopy lighting even though a baseline model cannot include shading elements?

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

For a project outside the U.S., how do I determine the climate zone?

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

Does all of Section 1.6 results have to be filled?

Ivan Priatman

Senior Designer

PT. Archimetric

LEEDuser Basic Member

4 thumbs up

Project location :

November 20, 2014

Dear LEED, We are trying to achieve points in EAp2 scorecard via Building Simulation Method. Since this is our first experience in using LEED, we only filled the information about Interior Lighting, Space Cooling, Pumps, Heat Rejection, Fans-Interior, and Receptacle Equipment on Section 1-6. Do we have to fill the other information such Exterior Lighting, Fans-Parking Garage, Elevators, etc? For your information, we have checked the provided automatic compliance and there was no problem occurred. Sincerely,

Post a reply

Marcus Sheffer

LEED Fellow

7group / Energy Opportunities

LEEDuser Expert

4454 thumbs up

Thu, 11/20/2014 - 15:05

You only need to fill in energy use for those end uses that exist in your building or in the Appendix G baseline. If any of the regulated (non-process) items are zero like exterior lighting, service hot water, space heating, etc. you should explain why that is the case. Keep in mind you are required to include all energy use within and associated with the project within the LEED boundary.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.