Compliance

Alicia Neubauer

Architect

Saavedra Gehlhausen Architects

LEEDuser Basic Member

0 thumbs up

August 6, 2013

We have a project that just went through Preliminary Design Review. The calculations for the project are meeting LEED requirements, we have demonstrated that with an excel spreadsheet that we are uploading. The LEED template, however, is not calculating the correct values.Is there a glinch in this template that USGBC/ GBCI is aware of? Should we submit by checking Alternative Compliance? Please respond soon. Thanks!

Post a reply

Susan Walter

HDR

LEEDuser Expert

894 thumbs up

Wed, 08/07/2013 - 17:16

First, verify the programming of y our worksheet and make sure the glitch isn't there. Then, I'd call the GBCI or contact them through the LO website if you suspect a wonky form. There really is no other solution.

Alicia Neubauer

Architect

Saavedra Gehlhausen Architects

LEEDuser Basic Member

0 thumbs up

Thu, 10/03/2013 - 17:53

We uploaded more information through a clarification request. The glitch was not reset.... I suggest you upload all the information that is needed to prove your case. Good luck! (we just completed design review)

Susan Walter

HDR

LEEDuser Expert

894 thumbs up

Thu, 10/03/2013 - 18:27

Congratulations on finishing your design review. Aside from this issue, do you have any more words of wisdom for other project teams?

Alicia Neubauer

Architect

Saavedra Gehlhausen Architects

LEEDuser Basic Member

0 thumbs up

Thu, 10/03/2013 - 18:53

words of wisdom?... we corresponded back and fourth about five times with the Review team on the Water Use Reduction prereq. That was a nailbiter too. I guess make sure that you upload all the documentation that you have.